CommunityInjection Technique

Always get air bubbles sticking to the side of the syringe.

5 replies6 peopleMar 10, 2026☆ Follow
Summary

how to get rid of air bubbles stuck in a syringe for subq injections

Small bubbles commonly remain even after flicking or priming and do not cause issues for subcutaneous use. People manage larger ones by expelling them, drawing extra air, or pulling slightly past the dose, while noting that slow draws and certain needle sizes help reduce them. The problem may stem from the syringe interior rather than technique alone.

What this discussion establishes

Nothing here is advice.

5 replies · 6 people
GreenPebble78archiveopening postMar 10

Anyone else run into this? Tapping the side and priming still leaves some bubbles behind. Any suggestions?

IronBramble31archiveMar 10

The bubbles still annoy me, but they do not seem to create any problems.

BlueTimber78archiveMar 10

It happens, so no need to stress. Checking how much air must be injected before any problems occur helped put my mind at ease.

CopperAlder51archiveMar 10

I push out any big ones, or draw a little extra air after filling and then push it out. A small bubble is not an issue with an SQ injection.

PlainAlder11archiveMar 10

This is my method. Draw the syringe back outside the vial to the dose amount, insert into the vial, then draw to that amount. I usually go a bit over so I can deal with bigger bubbles before pushing down to the right level. As noted, the little ones are not a problem. Draw slowly, especially with a small 30-31 needle.

BrightSignal76archiveMar 10

I think it must be the syringe. Some may have a different inside surface. Never saw this with hundreds of syringes until switching to these popular needles from the basic ones. I roll, flick, and flip until the stubborn bubbles merge so I can push them out. A little air probably does not matter for subq.

Related discussions

Add your experience

If you have tried it, this topic is still open. Sign in to reply — it takes a minute.