ForumDosing & Titration

Dosing a BPC-157 and TB-500 Blend

5 replies4 peopleJun 17, 2026☆ Follow
Summary

how to reconstitute and dose a 6mg/6mg BPC-157/TB-500 blend

The thread highlights that premixed blends create dosing conflicts because BPC-157 is typically used daily at lower microgram amounts while TB-500 follows a less frequent milligram schedule. One user shared that increasing from 0.5 mg to 1 mg daily of each produced no noticeable effects. Others note the math becomes simpler when peptides are purchased separately instead of in a fixed-ratio mix. A link to external 10 mg blend guidelines was suggested but requires adjustment for the 6/6 ratio here.

What this discussion establishesStill open

whether any dose of this specific 6/6 blend produces noticeable effects

Nothing here is advice.

5 replies · 4 people
RustMarble34archiveopening postJun 17

Suppose I have a 6 mg of each blend of those two peptides. How much bacteriostatic water should I add when reconstituting? Also how many times per week and at what dose should it be used?

CopperAlder51archiveJun 17

You might not be getting answers because the premade mix combines two peptides that call for different amounts and different timing. One is meant to be used every day while the other is only two or three times weekly, and their target strengths also differ. With a fixed blend you have to work out a compromise on both schedule and strength, then pick a water volume that gives you an easy-to-measure IU dose. It ends up being awkward. Maybe someone else has already tried this exact ratio.

PlainFenwick60archiveJun 17

There is a full set of instructions for reconstituting and dosing the 10 mg version of this peptide combination. It should help. Keep in mind it covers a 10/10 blend so some math will be required on your end.

PlainAnchor67archiveJun 18

I tried the wolverine stack once. Began with half a milligram of each every day but noticed no effects. Increased to one milligram daily and still no results so I stopped. Plenty of people say it works for them though. Check a guide on bac water amounts to work out the math.

RustMarble34archiveJun 18
↳ replying to @PlainFenwick60

Thank you so much, I really appreciate it!

RustMarble34archiveJun 18
↳ replying to @CopperAlder51

Yeah that checks out. Before my buddy picked up the blend I mentioned to him how it seemed pointless and just added unnecessary hassle. I also prefer getting them separately and doing the shots myself since it simplifies the numbers too.

Related discussions

Add your experience

If you have tried it, this topic is still open. Sign in to reply — it takes a minute.