The original poster shares mass test results from a 60mg kit showing swings between 65.19mg and 72.01mg and asks whether to average them or adjust dosing. Most replies suggest averaging the values, using the mean for calculations, and proceeding since the variation is small enough that effects would be undetectable. One user jokes about discarding it while another notes they treat vials at nominal weight unless wanting more precision. The poster confirms keeping all vials from a batch tested by multiple parties and mentions endotoxin levels but plans to continue anyway.
What this discussion establishesWhether the variation is large enough to matter or if the kit should simply be discarded.
Still openWhether the user can actually perceive dosing differences from the mass swings or if it is psychological.
Nothing here is advice.
Got this sixty milligram set back from testing and the weights read out as those six figures. Never run into variation this wide before so it's throwing me off. I normally just total the numbers and pick the middle one to move forward but the low to high spread here stands out more than usual. Feeding the top and bottom into the tool for a fifteen milligram target only shifts things by a couple units either way. Leaning toward the middle figure could work out fine. Over a year and a half into this whole thing without running into tough reactions yet I still prefer the numbers to line up precisely.
The gap from the weakest or strongest vial to the average is only about 5 percent, so nothing to be concerned about. Use the average in a reverse calculator along with the round unit count you want to inject each time, then reconstitute using whatever bac volume the calculator returns.
To be frank, just chuck that thing out. In fact, I could even handle getting rid of the package for nothing at all 😁
I'd pick that route myself. Spotting any difference would be impossible.
You actually mailed six from the ten containers in that package for analysis and saved the other four for later?
I smoothed out the variations first then tucked it into the icebox and went on with my usual routine since any disparity would go unnoticed by me anyway.
I usually just go by the labeled amount on the container without stressing over the exact mass. To be more precise on occasion I might assume each one holds 69 milligrams and base the dose calculation on it. It seems like several packages from one production lot got checked.
Actually that lot gained popularity after checks from the seller plus an outside lab. My ten remain with me. The measured toxins hit 77eu which raised some concern initially yet reviewing the newest details makes me confident my batch of 77 will turn out fine lol
It seems to me that I notice variations in how it affects me, and that's just how I operate. I've experimented by tweaking the amount slightly up or down, getting similar sensations, though maybe that's imaginary. So if I try it out and sense it's ineffective, I might add a bit extra the following day or whatever. Anyway, it's really minor in the grand scheme.
If you have tried it, this topic is still open. Sign in to reply — it takes a minute.