KeenFenwick81
archive participant · first seen Mar 7, 2026 · last active Aug 3
0topics
6replies
0likes
0same experience
0best answers
replied
NAD+ SubQ Injections: Dosing and Managing the Burn
With a 100 mg per ml mix, 80 units would actually be 80 mg, not micrograms. Most start around 5 mg then move to 25 mg. Jumping straight to …
Aug 3
replied
4mm vs 6mm pen needles
I'd pick the 6 mm size as well. Also check that the tips you buy are compatible with the pen so the hiding cap still works properly.
Jul 6
replied
BAC Water shelf life
I'm wondering about those containers that stay sealed. My usage runs around two milliliters each month, occasionally up to three. Still, I …
Jun 30
replied
Choosing an initial Tirzepatide dose for maintenance
Half a milligram seems quite low. I probably wouldn't begin below 2 mg. The usual starting amount is 2.5. Your call, but doing 2 or 2.5 onc…
Apr 17
replied
No one told me
You can also push a little air into the vial first so the vacuum is not as strong when the bac water goes in. I usually add one or two mill…
Apr 13
replied
3ml Pen Injector Pre-Purged Vial: Thoughts?
I just ordered some v4 pens and was thinking through the steps. It does use up a lot of supplies: one luer lock for reconstitution, a filte…
Mar 7