Reddish marks from retatrutide injections still there after 2 months — anyone else?

Any experience with it?

I apply this substance often to help with aches in my lower back. A couple of times I placed it on my abdomen for the marks left by reta. The marks had vanished by the next morning. Perhaps it was just luck but I doubt that. I always wash the spot thoroughly beforehand since anything sitting on the surface might get drawn in. That led me to research it further. My breath takes on a garlic scent that persists for twenty five hours.

Using good quality BAC water. Happened with more than one vial.

So I ended up with ten containers of GHKCU. Picked them up hoping they might help tighten loose skin, yet I feel unsure since studies on it look pretty thin. How did it turn out for others?

I've come across information indicating that ghkcu has been the subject of numerous investigations spanning many years. What worked for me involved obtaining a kpv kit and incorporating it with the ghk material. I started out using a minimal one milligram quantity to assess any sensitivity, administering it via injection into the outer part of my upper leg or my rear end. I maintained that amount over roughly seven days before progressing to two point five milligrams. I based the quantity solely on the ghkcu content instead of totaling the peptides.

I was wondering about blending the freeze dried version of KPV together with GHK. Haven't really looked into what KPV does yet it looks like it could be good.

I apply DMSO to my lower back and knees as well. This approach helped me avoid spinal injections around the upper lumbar area which could have caused additional harm. It eliminated the discomfort in those joints entirely. I combined it with an anti-fungal ointment to allow better absorption on my soles and finally cleared up a decades-old case of foot fungus that started during my time in the service. That experience opened the door for me to explore further options. 😂

Does DMSO wipe away whatever sits on the skin surface? That would make the marks disappear then?

I wondered if my needle was the issue or if I just didn't push it in far enough. The one I had measured short. Maybe a bad one threw off the balance with the mixing liquid too. When the tip stops above the fat layer the fluid ends up stuck right under the surface instead and creates a raised spot. Some might come back out on top and it stung more than usual because of all the nerves close by. The area turned a bit red and sore with some light discoloration and the stuff seemed to soak in at an uneven pace. I tried changing the angle a bit and lifting a fold of skin before going in and left any lump alone so it could settle on its own.

Telling apart what those marks are without knowing their exact dimensions, hue, outline or whether they stick out or not, plus no image, leaves some uncertainty. From what you said though, it seems you might have a habit of developing tiny excess tissue at the spots where you inject. Possibly similar to small keloid formations. They appear quite tiny, no more than a couple millimeters across, and larger ones would warrant checking with a skin specialist. Do you tend to form those raised scars or the thickened kind? Any shot could trigger this, so switching substances to address it risks creating additional marks. Using the leg area works better for you, that approach seems preferable. What length are the needles you're using, and how far in do they go? Going a little further into the fatty layer underneath might reduce visibility since most responsive cells cluster closer to the surface. You're probably employing slim ones around thirty gauge or so, not thick ones, right? Scars from such thin needles usually don't show up at all, even under close inspection, which means this is an unusual situation for you.

Every single time these raised scars appear on me without fail and it feels totally ridiculous. I figure the ones showing up now match that pattern as well. I fold the skin and deliver the shot correctly using syringes that measure eight millimeters at a thirty gauge thickness.